Inspiration Your Twin Bed With Storage Drawers
A platform bed is an elegant addition to any room. You can create a little extra storage space by adding twin bed with storage drawers. These fit on the platform and are very easy to add to your project. It will only take a few extra steps to add a lot of extra space. Design the twin bed with storage drawers. Measure the size of your mattress. Determine the number of drawers you want. Three on each side to work. One twin will have only one set of drawers. Also measure how much you want the base.
Set the bed frame for the twin bed with storage drawers. Start by cutting a piece of MDF length of bed and height you want your platform is. Then cut the board to the top and bottom part of frame. Screw them on the center piece. Cut the cuts that are connected to the central part of the mechanism of transverse support. Drawers are between each of the sections. You have two on each side of the middle part. Screw in place. Joints are staggered slightly to connect. Set tracks for drawers in cross section parts.
Close the bottom piece of MDF in connection with an electric screwdriver. Tighten the screws on each corner and one to two spaced along the frame feet. Turn the bed and screw the top piece of MDF board in the frame. Sand and stain the boards. Create your twin bed with storage drawers. The drawers should have a bottom piece and four sides. Sand, stain and add a handle to the front of the drawers. The size of the bed will determine the depth of the drawers. Drawers make approximately one smaller than the openings of the bed inch drawer. Place guides for drawers and then connect to the tracks inside the bed. Putting in place the drawers.